spi: spi-fsl-dspi: Halt the module after a new message transfer

The XSPI mode implementation in this driver still uses the EOQ flag to
signal the last word in a transmission and deassert the PCS signal.
However, at speeds lower than ~200kHZ, the PCS signal seems to remain
asserted even when SR[EOQF] = 1 indicates the end of a transmission.
This is a problem for target devices which require the deassertation of
the PCS signal between transfers.

Hence, this commit 'forces' the deassertation of the PCS by stopping the
module through MCR[HALT] after completing a new transfer. According to
the reference manual, the module stops or transitions from the Running
state to the Stopped state after the current frame, when any one of the
following conditions exist:
- The value of SR[EOQF] = 1.
- The chip is in Debug mode and the value of MCR[FRZ] = 1.
- The value of MCR[HALT] = 1.

This shouldn't be done if the last transfer in the message has cs_change
set.

Fixes: ea93ed4c ("spi: spi-fsl-dspi: Use EOQ for last word in buffer even for XSPI mode")
Signed-off-by: Bogdan-Gabriel Roman <bogdan-gabriel.roman@nxp.com>
Signed-off-by: Larisa Grigore <larisa.grigore@nxp.com>
Signed-off-by: James Clark <james.clark@linaro.org>
Link: https://patch.msgid.link/20250522-james-nxp-spi-v2-2-bea884630cfb@linaro.org


Signed-off-by: Mark Brown <broonie@kernel.org>