arm/arm64: gic: Check spurious and bad_sender in the active test

The gicv{2,3}-active test sends an IPI from the boot CPU to itself, then
checks that the interrupt has been received as expected. The
ipi_clear_active_handler() clears the active state of the interrupt with a
write to the GICD_ICACTIVER register instead of writing the to EOI
register.

When acknowledging the interrupt it is possible to get back an spurious
interrupt ID (ID 1023), and the interrupt handler increments the number of
spurious interrupts received on the current processor. However, this is not
checked at the end of the test. Let's also check for spurious interrupts,
like the IPI test does.

For IPIs on GICv2, the value returned by a read of the GICC_IAR register
performed when acknowledging the interrupt also contains the sender CPU
ID. Add a check for that too.

Reviewed-by: Eric Auger <eric.auger@redhat.com>